rider40life0
06-23-2008, 04:42 PM
well this is my first write up and i still need to finish it, but i'll post up the rest later. first i took a long look at the bike to get my ideas straight.
http://www.sharenow.com/base/content/12455/
unbolt the exhaust can, mine had three bolts
http://www.sharenow.com/base/content/12456/
remove the can (i like the look without)
http://www.sharenow.com/base/content/12457/
grind the rivets off to remove the cap (if yours have rivets)
http://www.sharenow.com/base/content/12459/
measure the can for your desired length. take a piece of paper or magazine spine and bend it around the can to get a straight line
marking. then mark your line around the can. rotate the can 3 inches at a time measuring each time to make sure your line is straight.
http://www.sharenow.com/base/content/12461/
make sure to stay away from useless tools like the ones that got me stuck this weekend
http://www.sharenow.com/base/content/12460/
so this is how i rode it to work today and i will post the rest of the pics when i am finished
http://www.sharenow.com/base/content/12462/
http://www.sharenow.com/base/content/12455/
unbolt the exhaust can, mine had three bolts
http://www.sharenow.com/base/content/12456/
remove the can (i like the look without)
http://www.sharenow.com/base/content/12457/
grind the rivets off to remove the cap (if yours have rivets)
http://www.sharenow.com/base/content/12459/
measure the can for your desired length. take a piece of paper or magazine spine and bend it around the can to get a straight line
marking. then mark your line around the can. rotate the can 3 inches at a time measuring each time to make sure your line is straight.
http://www.sharenow.com/base/content/12461/
make sure to stay away from useless tools like the ones that got me stuck this weekend
http://www.sharenow.com/base/content/12460/
so this is how i rode it to work today and i will post the rest of the pics when i am finished
http://www.sharenow.com/base/content/12462/